• 回答数

    2

  • 浏览数

    276

帅哥小蜜
首页 > 期刊论文 > 总磷测定毕业论文

2个回答 默认排序
  • 默认排序
  • 按时间排序

绿草泱泱

已采纳

Abstract: total phosphorus in water, nitrogen and COD (chemical oxygen demand) is reflected in the importance of water quality indicators, in general, because of self-purification capacity of water, natural water of nitrogen and phosphorus content and COD value is not high and the trend On the stability. But with the accelerated process of urbanization, urban industrial building high-speed development in recent years, urban sewage and industrial wastewater emissions were rising trend year by year, fertilizer, metallurgy, printing and dyeing, synthetic detergent industries such as wastewater, sewage life Water and water for agricultural use, with a large number of nitrogen and phosphorus compounds, the COD value is high. Through various channels such sewage into the water, all kinds of phosphate in water, organic and inorganic nitrogen content of nitrogen compounds will continue to improve, a direct impact on water quality. Material increase in nitrogen and phosphorus in water, algae and micro-organisms will lead to excessive breeding, large consumption of dissolved oxygen in water. When more than the load of water, will result in decreased water transparency, eutrophication, and other adverse effects, so that the water quality the other hand, China's annual COD only in the liquid waste generated in the form of environmental emissions of mercury and silver of sulfuric acid on a few tonnes, the environmental pollution caused by the secondary has been not to be ignored. Determination of potassium dichromate and used water samples COD not only time-consuming energy, water back, reagent consumption also great. It can be said that we have been adopted by the COD of the water quality is not consistent with the way the concept of environmental sum up, with the water quality of the increasing deterioration of the situation, water quality monitoring in the determination of nitrogen and phosphorus to the improvement of water quality monitoring and protection is of great significance, and improve the existing COD or on the determination of low energy consumption, Reagents used and less time-precise determination of the new, equally positive and important article from the multi-pronged approach to study high temperature and high pressure digestion, microwave confined digestion, digestion and a series of heated water bath TP digestion of the total nitrogen, as well as the standard return, microwave digestion and a series of COD determination of the digestion. Through the TP TN COD content of the results of different methods of comparison, and various microwave digestion time and return to standard time that the effect of digestion sample comparison of research, improvement of the original determination, or find a new technology Means to achieve rapid and effective sample decomposition, shorten the time for the purpose of digestion, and can greatly reduce the digestion of the samples in the loss and pollution, improve the determination of precision and accuracy, expanding the scope of application methods, while exploring a new approach And the classic method of comparability, and its practical application in the superiority of developed a variety of water suitable for TP TN COD of the rapid digestion of accurate, the new method is simple system, to improve the water and wastewater monitoring Analysis at the same time, to a certain social words: total phosphorus (TP); Total Nitrogen (TN); chemical oxygen demand (COD); microwave digestion; optimum conditions

143 评论

小笨猪seven

①打开消解系统开关,设定温度为120℃,定时为30分钟,启动消解系统,开始升温。同时对测定系统开机进行预热,预热时间至少10分钟;②准备数支反应管,置于冷却架的空冷槽上。

①准确量取8ml蒸馏水加到“0”号反应管中;②然后分别准确量取各水样8mL,依次加入到其他反应管中。

依次向各个反应管中加入1mL的P1试剂,加盖混匀。

消解器升温完成后,将反应管依次放入仪器消解孔中。按消解系统的【启动/停止】键,开始消解计时,消解系统会自动倒计时提醒。

消解完成后将各样品依次放到冷却架。

将各反应管放到冷却架的水冷槽中(提前在水冷槽中加入自来水)。

①向水冷却完成的各反应管中分别加入1mL P2试剂混匀,30秒后再分别加1mL P3试剂充分混匀;②静置15分钟;③依次倒入对应编号的比色皿。

先将“0”号比色皿(空白溶液)放入主机的比色槽中,并关闭上盖。

按【设置/空白】键,仪器屏幕将如图显示。然后将“0”号比色皿(空白溶液)从仪器中拿出。

再将“1”号比色皿,放入比色槽中,并关闭上盖。此时屏幕上所显示的结果即为“1”号样品的总磷值;其他样品同上,依次放入比色槽后,关闭上盖,仪器将显示出该样品的总磷值。

133 评论

相关问答

  • 测量毕业论文总结

    GPS在工程测量中的优化与应用探讨 摘要]鉴于GPS相对于全站仪等传统测量技术具有全天候、高精度、自动化、高效益等优势,本文通过对几个工程测量实例的实 施、对比

    夜很*^*安静 3人参与回答 2023-12-08
  • 磷酸铁锂毕业论文

    太多了,先说正极,钴酸锂,镍酸锂,锰酸锂,磷酸铁锂,还有三元的,这是基本的,还有从这些衍生出来的,手机电池用的是钴酸锂。负极,天然石墨,人工石墨,无定形碳,中间

    Mr.白马王爷 7人参与回答 2023-12-11
  • 总磷测定毕业论文

    Abstract: total phosphorus in water, nitrogen and COD (chemical oxygen demand) i

    帅哥小蜜 2人参与回答 2023-12-06
  • 废水中总磷的检测与分析论文

    一般用分光光度计,也就是钼酸铵法。中 华 人 民 共 和 国 行 业 标 准 锅炉用水和冷却水分析方法总磷的测定 钼酸铵分光光度法 GB 69

    mimi若闻 3人参与回答 2023-12-06
  • 茶叶有机磷检测论文题目

    我们网站有关于农药残留检测,预防,还有解决的办法,在热点咨讯里边,有需要可以去看看的

    WHMooooooooo 4人参与回答 2023-12-08